Large span tension set is suitable for overhead line ADSS optical cable, usage of poles and towers. For the integrity and performance of the ADSS tension set clamp function, in principle, the preformed dead end clamp can only be used once to keep safety and it is not allowed to repeat using. For good performance and personal safety, it is necessary to make sure whether the model and specifications of the fittings are consistent with the requirements of the optical cable before use.
Large span tension set for ADSS with advantages below:
1.One-stop raw material supply completely
2.Stable transmission, low loss
3.Fast delivery, safe package, long service life
Sn | Model No. | Suitable for ADSS cable range(mm) |
300M span | ANZ 030/0940 | 8.6-9.4 |
ANZ 030/1010 | 9.5-10.1 | |
ANZ 030/1070 | 10.2-10.7 | |
ANZ 030/1140 | 10.8-11.4 | |
ANZ 030/1220 | 11.5-12.2 | |
ANZ 030/1290 | 12.3-12.9 | |
ANZ 030/1370 | 13.0-13.7 | |
400M span | ANZ 040/1220 | 11.5-12.2 |
ANZ 040/1290 | 12.3-12.9 | |
ANZ 040/1370 | 13.0-13.7 | |
ANZ 040/1460 | 13.8-14.6 | |
ANZ 040/1550 | 14.7-15.5 | |
ANZ 040/1650 | 15.6-16.5 | |
500M span | ANZ 050/1370 | 13.0-13.7 |
ANZ 050/1460 | 13.8-14.6 | |
ANZ 050/1550 | 14.7-15.5 | |
ANZ 050/1650 | 15.6-16.5 |
Installation steps:
1.Align the installation mark of the outer wire with the optical cable and mark the installation.
2.Align the first set of inner wire marks with the optical cable marks.
3.The third group does the same as the second group.
4.All the inner wires are installed.
5.Align the outer wire installation mark with the inner wire installation mark.
6.Wrap one leg first.
7.Wind the other leg again.
8. Wrap the end of the outer wire well.
Submitted successfully
We will contact you as soon as possible