BUCKLE FOR STEEL STRAPPING TAPE

The stainless steel buckle with tooth-shaped serrations and a certain arc on the back, which Bundle cables and signs can provide the greatest bundling strength. 

Features:

-Buckles with rounded edges

-With a toothed cavity for better grip of the steel tape

-Flat body for fastening to the steel tape

-With fins for maximum tension and fixed and secure grip of the steel tape

-The buckle is for ¾-inch steel strapping tape.

Packaging:

The buckles packaging in plastic bags of 100 units and these in turn in cardboard boxes adequately protected against damage or humidity, with the requested customer information.

Installation steps: 

1.According to the actual use, cut a certain length of stainless steel cable tie, thread the buckle to one end of the tape, and reserve a length of about 5cm(Cutting length = the required length of the bundle+5cm+10cm).

2.Bend the reserved tape to preliminarily fix the stainless steel buckle. 

3.When strapping, wear the other end of the stainless steel tape, and reserve a length of at least about 10cm for the strap tightening machine to pull into the tape.

4.Clamping the tape with a tightening machine, and start to shake the rocker arm to slowly pull in the tape. Make sure that the tape is just tightened. Do not tighten the tape too much to avoid damage the tool.

5.When the tape is tightened, fold back the entire strap tightening machine and cut the tape by turning the blade handle. 

6.Knock the two corners of the buckle flat with a hammer to block the final tape head to complete the binding process.