Pole Install Suspension Clamp for ADSS Cable

The tangent clamp is a kind of linear suspension clamp, which is mainly used to provide a light, simple, and low-cost protective installation clamp for small-span overhead optical cables. It is especially suitable for the needs of urban communication network construction and transformation.

This product is a single hanging point for overhead lines, single hanging, no internal and external pre-twisted wire clamps, this product plays a fixed and traction role, can simply adapt to the problem of unbalanced forces on both sides, and can more effectively adapt to both sides Torque and moment problems caused by different pulling forces.


  Contact Now
Product Details

Tangent suspension clamp for FOR FIBER OPTIC CABLE ADSS Span 120m Diameter of ADSS cable:  11.8 ± 0.4 mm.  It is mainly used for the installation of optical cables on short-span linear pole towers below 150 meters, or pole towers with a rotation angle of less than 15 degrees.

This product has rubber clamps and one-piece aluminum alloy casing (butterfly type). This product has a strong grip on the cable, anti-loose and anti-skid, can be suitable for 0-100m small pitch difference, a variety of sizes of cables, simple and reliable structure, this product is matched with other hardware in the line, and installed in a variety of Pole towers, such as strain-resistant power transmission towers and strain-resistant poles, are often used for small-angle corners of lines and locations where the spatial potential is not too high. It is a mature and marketable product!

Pole Install Suspension Clamp for ADSS Cable

Specification list:

Sn

Model No.

Cable range(mm)

1

ACQ 100/1110

9.0-11.1

2

ACQ 100/1330

11.2-13.3

3

ACQ 100/1550

13.4-15.5

Safety Note: 

It must be ensured that the extreme contact pressure under the fitting does not exceed the extrusion design limit of the ADSS optical cable. In the use of the tension value, it is necessary to ensure that the ADSS optical cable and the wire do not whip, and the load on the tower is as small as possible to avoid safety problems.


Product form